How to Draw Walls in a Floor Plan: Exact Lengths and Angles
Web editor · video 2 of 9 · 1:08 · Watch on YouTube
How to draw walls in a floor plan with vPlan's online editor: click to place walls one after another, type exact lengths and angles, snap corners to the ends of other walls, keep walls straight with Ortho (F8), and undo mistakes.
In this video
- Pick the Wall tool, or press W
- Click to start a wall and click again to end it; the next wall starts from that point
- Press Esc to stop drawing
- Type a length and press Enter for a wall of an exact size
- Press Tab to type an angle: 90 degrees turns the next wall straight up
- Walls snap to the ends of other walls, so corners meet cleanly
- Turn on Ortho with F8 to keep walls horizontal or vertical
- Undo with Ctrl Z, redo with Ctrl Shift Z
Transcript
To draw walls, pick the Wall tool from the rail, or press W.
Click once to start a wall, then click again to end it. The next wall starts from that point, so you can draw one after another.
Press Escape once to stop drawing.
For exact sizes, click to start, point the way the wall should go, and type its length. Press Enter to place it.
Press Tab to type an angle as well. Ninety degrees turns the next wall straight up. Then Tab back, and type ten feet.
As you draw, vPlan snaps to the ends of other walls, so corners meet cleanly. Press F8 to turn on Ortho, and walls stay perfectly horizontal or vertical.
Made a mistake? Press Control Z to undo, and Control Shift Z to redo.
Next, we'll turn walls into a room.


